Otherwise, code 12 will flash 3 times before flashing the fault codes. This code 12 means the diagnostic system is normal and will repeat itself continuously if there are no trouble codes. All codes should start with code 12 which is one long flash followed by 2 short flashes. Turn your ignition key on with engine off and the codes should start to blink. To get the check engine codes to flash in your dash panel, use a jumper wire or a paper clip and connect terminals A and B of the diagnostic connector. K621 ford engine codes list driver#The diagnostic connector is located under the dash panel by the driver side.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |